| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: libiscsi: Reject a negative task index from parse_pdu_itt
A transport that implements parse_pdu_itt hands libiscsi an index taken
from the PDU, and both lookups bound it from above only:
if (i >= session->cmds_max)
i and cmds_max are both int, so a negative index passes and
session->cmds[i] is read from before the array.
be2iscsi produces one. beiscsi_parse_pdu() assigns the raw tag,
*index = (int)itt;
and beiscsi_complete_pdu() forwards an unsolicited NOP-In from the
hardware async ring without replacing its ITT, so the value is the
target's. It also reports the session's own age rather than the one in
the tag, which leaves the age comparison in iscsi_verify_itt() with
nothing to reject.
Bound the index from below in both lookups. |
| GNU mtools before 4.0.50 has an out-of-bounds write in parse_vses in vfat.c. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Keep the predicate limit separate from program capacity
predicate_parse() adds two to nr_preds to reserve the terminal TRUE
and FALSE entries. It also uses that increased value as the limit for
parsed predicates. If the initial count is smaller than the number
actually parsed, the program can fill the allocation and subsequent
accesses can go past its end.
Keep nr_preds as the predicate limit and use a separate value for the
allocation size. This leaves space for both terminal entries and a
zeroed entry when parsing stops at the limit. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix heap overflow in cifs_do_set_acl()
cifs_set_acl() validates ACL size using posix_acl_xattr_size():
4 + (count * 8) // 4-byte header + 8 bytes per ACE
cifs_do_set_acl() then calls posix_acl_to_cifs() to write the CIFS
wire format into the same buffer:
6 + (count * 10) // 6-byte header + 10 bytes per ACE
An ACL that passes the xattr-based check in cifs_set_acl() can
overflow the heap when posix_acl_to_cifs() writes the larger CIFS
format.
Validate the CIFS format size against the remaining buffer space and
USHRT_MAX before converting--data_count is __u16, so sizes above
USHRT_MAX truncate the on-wire packet length, causing the server to
apply a partial ACL. Replace MaxDataCount = 1000 with
min(CIFSMaxBufSize, USHRT_MAX). |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Check operator stack capacity before pushing
predicate_parse() uses the first operator stack entry before processing
any opening parentheses. A push then increments top before writing.
The existing check still permits that write when top already points to
the last allocated entry, which can access beyond the operator stack.
Reject the push when top reaches the last allocated entry. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: fix incorrect MFT record pointer passed to ntfs_attr_record_resize
ntfs_new_attr_flags() passes the wrong MFT record to ntfs_attr_record_resize().
When the attribute is in an extent record, ctx->mrec points to the extent
but the function receives the base record pointer m, causing incorrect
size calculations in memmove.
Fix by passing ctx->mrec (the actual MFT record containing the attribute)
instead of m (the base MFT record) to ntfs_attr_record_resize(). |
| A flaw was found in GCC libstdc++. When an application extracts data into a bitset from a wide-character stream, internal stack memory allocation fails to properly account for character size and alignment. An attacker capable of supplying crafted input to an affected application could trigger a stack-based buffer overflow leading denial of service (DoS). |
| DevilutionX 1.4.0 through 1.5.5 contains a heap buffer overflow vulnerability in the bundled libmpq libmpq__archive_dup routine when opening crafted MPQ archives. Attackers can supply an MPQ archive whose block table count exceeds its hash table count, causing memcpy to overflow the heap during startup and crash the game. |
| FLTK through 1.4.5 contains an integer overflow vulnerability in Fl_BMP_Image::load_bmp_() that causes undersized pixel buffer allocation from file-supplied width and height. Attackers can supply a crafted BMP or ICO file with large dimensions so row decoding writes file-derived data past the heap buffer, corrupting the application heap. |
| Out-of-bounds Write Vulnerability in JP1 Products.
This issue affects JP1/Integrated Management 3 - Manager: from 13-00 before 13-50-31; JP1/Automatic Job Management System 3 - Manager: from 13-00 before 13-50-31; JP1/Automatic Job Management System 3 - Agent: from 13-00 before 13-50-31; JP1/Automatic Job Management System 3 - Agent Minimal Edition: from 13-00 before 13-50-31; JP1/Base: from 11-00 before 12-50-54. |
| A flaw was found in dnsmasq. After a reduction of internal domain-name buffer sizes, the DNSSEC validator can write a few bytes past a name buffer when converting names to and from DNS wire format. An attacker who can cause the server to validate a crafted DNSSEC response may overwrite a small amount of adjacent heap metadata. DNSSEC support is not compiled in by default and must also be enabled at runtime. |
| libass is a portable subtitle renderer for the ASS/SSA (Advanced Substation Alpha/Substation Alpha) subtitle format. From 0.17.4 until 0.17.5, libass event pruning does not guard negative Matroska `ReadOrder` values, allowing an attacker to clear arbitrarily many bits to zero at attacker-controlled positions near the NULL pointer. Exploitation requires a malicious Matroska stream loaded through `ass_process_chunk`, enabled read-order checking, and later pruning of the malicious events. Read-order checking is enabled by default unless `ass_set_check_readorder` is called with zero; pruning must occur explicitly through `ass_prune_events` or through automatic pruning previously enabled with `ass_configure_prune`. On common systems with arithmetic right shift, 32-bit int values, the upper address region reserved to the kernel, and matching binary/kernel architecture, the expected consequence is denial of service. More extensive exploitation on uncommon systems is theoretical and strongly constrained by the target addresses, bit-clearing-only mutation, and ASLR. This issue is fixed in version 0.17.5. |
| libass is a portable subtitle renderer for the `ASS`/SSA (Advanced Substation Alpha/Substation Alpha) subtitle format. Prior to 0.17.5, libass can overread and overwrite the glyph array in `wrap_lines_measure` while rendering malicious `ASS` content. In `wrap modes other than two`, a final line ending with a literal backslash-n sequence and otherwise consisting only of such sequences or spaces can remain after early trimming and make the line-measurement loops overshoot by one glyph. When the total text size exactly matches the allocated glyph-array capacity, the first loop reads an uninitialized 32-bit fixed-point `pos.x` value, although that value is not subsequently used. The second loop writes `pos.x` and `pos.y` beyond the array, zeroing the first and adding an attacker-controllable offset to the second. No actual exploitation beyond possible denial of service is known; broader exploitation is theoretical and constrained by the addresses, limited writes, and ASLR. This issue is fixed in version 0.17.5. |
| Scribus before 1.6.7 contains a heap out-of-bounds write vulnerability in the scimgdataloader_psd loader that uses unchecked PSD file values as lookup array indexes. Attackers can convince users to place or import a crafted PSD file to corrupt heap memory, causing crashes and potentially code execution as the user. |
| Scribus before 1.6.7 contains a heap buffer overflow vulnerability in the PICT image loader and import plugin that allows attackers to corrupt heap memory by supplying an unchecked bytesPerLine value. Attackers can craft a PICT file whose bytesPerLine exceeds the QImage scanline size, so placing or importing it crashes Scribus and may execute code as the user. |
| Scribus before 1.6.7 contains an out-of-bounds write vulnerability in the importdrw Micrografx Draw plugin that uses an unvalidated y offset to select image scanlines. Attackers can craft a DRW file that, when imported by a user, writes decoded bitmap data outside the heap image buffer, causing crashes or code execution. |
| Scribus before 1.6.7 contains a heap buffer overflow vulnerability in the Mac PICT image loader and import plugin when unpacking 4-bit indexed pixel data. Attackers can supply a crafted PICT file with inconsistent width and row data that, when placed or imported, writes out of bounds, causing crashes or code execution. |
| Scribus before 1.6.7 contains an out-of-bounds memory access vulnerability in the importsvm plugin that fails to verify bitmap and transparency mask dimensions match. Attackers can supply a crafted SVM file with mismatched mask dimensions to trigger heap reads and writes, causing crashes or code execution as the user. |
| An out-of-bounds write issue was addressed with improved bounds checking. This issue is fixed in iOS 26.7 and iPadOS 26.7, macOS Sequoia 15.8, macOS Tahoe 26.7. An app may be able to cause unexpected system termination. |
| KeePassXC is a cross-platform community-driven port of the Windows application KeePass Password Safe. From 2.3.0 until 2.8.0, KeePassXC browser integration encrypts authorized responses in src/browser/BrowserMessageBuilder.cpp using a fixed 1 MiB output vector even though Botan::Sodium::crypto_box_easy() writes the plaintext length plus crypto_box_MACBYTES. A browser-protocol client that can access the per-user IPC endpoint, has a valid database association, and causes an unlocked database to generate and encrypt a sufficiently large authorized response can trigger a sequential out-of-bounds write before any response is delivered. This issue is fixed in version 2.8.0. |
